Zyliss driver tip

Driver tip (SWISSREX-spare part p4)

Turning driver made of steel, with cylindrical shaft for clamping

This driver is for clamping in the drill chuck of a drill, a motor (NOT router motor) or a lathe and for driving a long wood workpiece. driving a long wood workpiece for wood turning.
However, the driver tip can also be clamped in an already mounted jaw chuck.

This quality driver tip is suitable for all types of wood, as its special geometry prevents the wood from splitting, even if the tip is forcefully driven into the wood! Please refer to the photos.

Caution:
Never use this woodturning driver with a milling motor or in place of a milling cutter.

Technical data:

• Diameter of the mandrel: 9mm
• Length of the mandrel: 25mm
• Overall length:45mm
• Diameter of the driver: 18mm
• The middle centering point protrudes slightlyto facilitate the centric attachment of the driver
• The four flights-"teeth" are offset to improve traction and prevent splitting of the wood

• For workpieces with a maximum length of 800mm, Ø 220mm, center height 110mm (longer possible with accessories)
• Drive with standard drill (Euro standard Ø 43mm) or with our powerful universal motor
• With ball-bearing tailstock center and driver center
• 5 year full guarantee!

Outer diameter: 43 mm, inner diameter: 38.1 mm (1.5")

SWISSREX Faceplate, 150 mm diameter

Supplied with 3 wood screws each, 3 different sizes

Please note:
Many photos showApplication pictures including the basic System-Workshop unit SWISSREX.
The System-Workshop and the respective accessories as well as any other tools & machines must be ordered separately.