ZYLISS / Z-VISE storage case - without contents

For secure clamping of large workpieces for surface and edge processing

These protective jaws are used for metalworking and protect the surfaces of the clamping jaws from pressure marks and scratches.
These protective jaws are not sold individually, but always in pairs (price shown: for 1 pair).

The additional jaws are attached to the lower jaw or the outer jaw and are used in the same way as the plastic jaws to protect softwood or sensitive surfaces when the clamping device is used as a workbench.
These additional jaws are not sold individually, but always in pairs (price shown: for 1 pair).

These pipe jaws are used for clamping round, angular pipes and rods, such as for bicycles, billiard cues etc.
The pipe jaws are 360° adjustable and enable two workpieces to be clamped at the same time, for example for gluing dowel joints.
These pipe jaws are not sold individually, but always in pairs (price shown: for 1 pair).

Original Zyliss turntable - Swiss make

The drill holder makes it possible to use the clamping device as a sanding device or drill stand.

The drill holder is an accessory to the basic unit and is supplied without any other parts (most of the photos show various applications together with the basic device).

Woodturning driver made of steel, with cylindrical shaft for clamping

Made for Zyliss woodturning lathe

This driver is intended for clamping in the drill chuck of a drill press or wood lathe and for driving a long wood workpiece when wood turning.

Technical specifications:

• Diameter of the mandrel: 8mm
• Length of the mandrel: 20mm
• Overall length: approx. 40mm
• Diameter of the driver: 14mm
• The middle centering point protrudes slightly to make it easier to attach the driver centrally
• The two drivers"prongs" are offset to prevent splitting of the wood as far as possible