ZYLISS / Z-VISE storage case - without contents

Woodturning driver made of steel, with cylindrical shaft for clamping

Made for Zyliss woodturning lathe

This driver is intended for clamping in the drill chuck of a drill press or wood lathe and for driving a long wood workpiece when wood turning.

Technical specifications:

• Diameter of the mandrel: 8mm
• Length of the mandrel: 20mm
• Overall length: approx. 40mm
• Diameter of the driver: 14mm
• The middle centering point protrudes slightly to make it easier to attach the driver centrally
• The two drivers"prongs" are offset to prevent splitting of the wood as far as possible

These protective jaws are used for metalworking and protect the surfaces of the clamping jaws from pressure marks and scratches.
These protective jaws are not sold individually, but always in pairs (price shown: for 1 pair).

The plastic jaws supplied with the clamping device are placed over the upper jaws and are used for clamping softwood or other sensitive surfaces such as glass, plastic, etc.
These plastic jaws are not sold individually, but always in pairs (price shown: for 1 pair).

For secure clamping of large workpieces for surface and edge processing

The additional jaws are attached to the lower jaw or the outer jaw and are used in the same way as the plastic jaws to protect softwood or sensitive surfaces when the clamping device is used as a workbench.
These additional jaws are not sold individually, but always in pairs (price shown: for 1 pair).

These pipe jaws are used for clamping round, angular pipes and rods, such as for bicycles, billiard cues etc.
The pipe jaws are 360° adjustable and enable two workpieces to be clamped at the same time, for example for gluing dowel joints.
These pipe jaws are not sold individually, but always in pairs (price shown: for 1 pair).