SWISSREX turning support (p5)

Driver tip (SWISSREX-spare part p4)

Turning driver made of steel, with cylindrical shaft for clamping

This driver is for clamping in the drill chuck of a drill, a motor (NOT router motor) or a lathe and for driving a long wood workpiece. driving a long wood workpiece for wood turning.
However, the driver tip can also be clamped in an already mounted jaw chuck.

This quality driver tip is suitable for all types of wood, as its special geometry prevents the wood from splitting, even if the tip is forcefully driven into the wood! Please refer to the photos.

Caution:
Never use this woodturning driver with a milling motor or in place of a milling cutter.

Technical data:

• Diameter of the mandrel: 9mm
• Length of the mandrel: 25mm
• Overall length:45mm
• Diameter of the driver: 18mm
• The middle centering point protrudes slightlyto facilitate the centric attachment of the driver
• The four flights-"teeth" are offset to improve traction and prevent splitting of the wood

Woodturning driver made of steel, with cylindrical shaft for clamping

Made for Zyliss woodturning lathe

This driver is intended for clamping in the drill chuck of a drill press or wood lathe and for driving a long wood workpiece when wood turning.

Technical specifications:

• Diameter of the mandrel: 8mm
• Length of the mandrel: 20mm
• Overall length: approx. 40mm
• Diameter of the driver: 14mm
• The middle centering point protrudes slightly to make it easier to attach the driver centrally
• The two drivers"prongs" are offset to prevent splitting of the wood as far as possible

These pipe jaws are used for clamping round, angular pipes and rods, such as for bicycles, billiard cues etc.
The pipe jaws are 360° adjustable and enable two workpieces to be clamped at the same time, for example for gluing dowel joints.
These pipe jaws are not sold individually, but always in pairs (price shown: for 1 pair).

SWISSREX Faceplate, 150 mm diameter

Supplied with 3 wood screws each, 3 different sizes

Please note:
Many photos showApplication pictures including the basic System-Workshop unit SWISSREX.
The System-Workshop and the respective accessories as well as any other tools & machines must be ordered separately.